HH1 Asset Area
The HH1 380 kV substation in StroomPlot (see marked up area on plot plan in figure 1 below) was handed over from HH1 Project Organization to the HH1 Asset Team on16th Dec 2024. After handover all activities in this area will fall under HH1 Asset regime and Asset Team responsibility. Work procedures applicable for contracted work on the HH1 380 kV Plot can be accessed via the weblinks below. Please note that these asset work procedures may deviate from procedures applicable in other areas still working under HH1 Project regime (https://contractorshollandhydrogen.nl/hsse-ms/).
For queries contact:
HH1 Asset HSSE Lead: Stephan.montel@shell.com
For requesting the permits to work in Stroomplot, please contact zaakir.asman@shell.com
Online Safety Training for work in Stroomplot is scheduled for Tuesday and Thursday between 10:00 and 10:45 by zaakir.asman@shell.com .
For queries contact:
HH1 Asset HSSE Lead: Stephan.montel@shell.com
For requesting the permits to work in Stroomplot, please contact zaakir.asman@shell.com
Online Safety Training for work in Stroomplot is scheduled for Tuesday and Thursday between 10:00 and 10:45 by zaakir.asman@shell.com .
Relevant HH1 Asset Procedures:
- HH1 LMS AM 01.003 HSSE And SP Organisation Accountability People Skills And Competence
- HH1 LMS AOP 02.001 Management Of Change
- HH1 LMS AOP 02.017 Electrical Safety
- HH1 LMS PM 02.003 Permit To Work
- HH1 LMS PM 02.005 Safe Isolation
- HH1 LMS HSE 02.001 Managing Occupational Health And Safety And Social Performance
- HH1 LMS HSE 02.002 Emergency Spill Preparedness And Response Management
Figure 1: HH1 Plot with 380 kV Plot highlighted in yellow, where these procedures are mandatory:
Stroom plot is highlighted in yellow.
Disclaimer: Hyperlinks in HH1 Asset Procedures on the contractor website may refer to HH1 Asset Procedures of a confidential nature. These HH1 Asset Procedures cannot be accessed from the contractor website and these HH1 Asset Procedures are not on the list of work instructions to be selected. If you have any questions about this, please contact your point of contact within Shell.